Analysis of the cause of the shake of the stone crusher during the operation
11 Apr,2020 UTC+8 Views:
During the normal operation of the stone crusher equipment, why does the E-board jitter suddenly appear? What causes this? Today, we learned that the technical staff of Great Wall Casting Steel that there may be some reasons for jitter:
1. The lining plate of the crushing cavity of the jaw crusher has become loose and falling off, and the jaw plate has to hit the tooth plate, which will cause the tooth plate to lose balance and eventually cause abnormal jitter.
2. During the operation of the fixed equipment between the crushing equipment and the jaw plate, the loosening or bolt breakage caused the tooth plate to loosen. The tooth plate and other parts of the inner cavity collided with each other during operation, which will aggravate both Between jitter frequencies.
The above two are the causes of jitters summarized by the technicians, then we can implement some operations based on these reasons to effectively avoid jitter:
1. When the crusher is in production, it must be fully lubricated to the corresponding parts.
2. Regularly check whether the jaw inside the crusher is intact. If there is a certain amount of wear, replace it in time.
1. The lining plate of the crushing cavity of the jaw crusher has become loose and falling off, and the jaw plate has to hit the tooth plate, which will cause the tooth plate to lose balance and eventually cause abnormal jitter.
2. During the operation of the fixed equipment between the crushing equipment and the jaw plate, the loosening or bolt breakage caused the tooth plate to loosen. The tooth plate and other parts of the inner cavity collided with each other during operation, which will aggravate both Between jitter frequencies.
The above two are the causes of jitters summarized by the technicians, then we can implement some operations based on these reasons to effectively avoid jitter:
1. When the crusher is in production, it must be fully lubricated to the corresponding parts.
2. Regularly check whether the jaw inside the crusher is intact. If there is a certain amount of wear, replace it in time.
